Hydranautics SWC5-LD-4040 RO Membrane

Kami adalah importir distributor agen dan supplier Hydranautics SWC5-LD-4040 RO Membrane terlengkap menyediakan berbagai kebutuhan spare part water treatment untuk keperluan industri dengan kualitas dan harga terbaik.

Description Hydranautics SWC5-LD-4040 Membrane

Configuration : Low Fouling Spiral Wound

Membrane Polymer : Composite Polyamide

Membrane Active Area : 80 ft2 (7.43 m2)

Feed Spacer : 34 mil (0.864 mm)

SWC5 membranes provide optimum salt rejection and permeate flows. They are chosen when lower permeate TDS and lower feed pressures are needed. SWC5 hydranautics membranes offer highest energy efficiency at lowest costs and are used in mega desalination plants. SWC5 membranes are available in two different types of variants, LD and MAX

Low differential LD Technology® models are offered to minimize colloidal fouling when used with conventional pre-treatment equipment. They offer consistently low feed pressures and highest duration between two successive cleanings.

The MAX models have a 440 ft2 (40.9 m2) active membrane surface area. They provide excellent performance with high TDS and boron removal from warm waters.

Specified Performance

· Permeate Flow: 1,750 gpd (6.62 m3/d)

· Salt Rejection: 99.7% (99.5% minimum)

· Test Conditions: 32000 ppm NaCl solution

· 800 psi (5.5 MPa) Applied Pressure

· 77 ^oF (25 ^oC) Operating Temperature

· 10% Permeate Recovery

· 6.5 - 7.0 pH Range

The Specified Performance is based on data taken after approximately 30 minutes of operation. Actual testing of elements may be done at conditions which vary from these exact values; in which case, the performance is normalized back to these standard conditions. Permeate flow for individual elements may vary +25 / -15 percent from the value specified.